205 lines
6.5 KiB
C
205 lines
6.5 KiB
C
/*
|
|
* linux/arch/alpha/kernel/pci_impl.h
|
|
*
|
|
* This file contains declarations and inline functions for interfacing
|
|
* with the PCI initialization routines.
|
|
*/
|
|
|
|
struct pci_dev;
|
|
struct pci_controller;
|
|
struct pci_iommu_arena;
|
|
|
|
/*
|
|
* We can't just blindly use 64K for machines with EISA busses; they
|
|
* may also have PCI-PCI bridges present, and then we'd configure the
|
|
* bridge incorrectly.
|
|
*
|
|
* Also, we start at 0x8000 or 0x9000, in hopes to get all devices'
|
|
* IO space areas allocated *before* 0xC000; this is because certain
|
|
* BIOSes (Millennium for one) use PCI Config space "mechanism #2"
|
|
* accesses to probe the bus. If a device's registers appear at 0xC000,
|
|
* it may see an INx/OUTx at that address during BIOS emulation of the
|
|
* VGA BIOS, and some cards, notably Adaptec 2940UW, take mortal offense.
|
|
*/
|
|
|
|
#define EISA_DEFAULT_IO_BASE 0x9000 /* start above 8th slot */
|
|
#define DEFAULT_IO_BASE 0x8000 /* start at 8th slot */
|
|
|
|
/*
|
|
* We try to make the DEFAULT_MEM_BASE addresses *always* have more than
|
|
* a single bit set. This is so that devices like the broken Myrinet card
|
|
* will always have a PCI memory address that will never match a IDSEL
|
|
* address in PCI Config space, which can cause problems with early rev cards.
|
|
*/
|
|
|
|
/*
|
|
* An XL is AVANTI (APECS) family, *but* it has only 27 bits of ISA address
|
|
* that get passed through the PCI<->ISA bridge chip. Although this causes
|
|
* us to set the PCI->Mem window bases lower than normal, we still allocate
|
|
* PCI bus devices' memory addresses *below* the low DMA mapping window,
|
|
* and hope they fit below 64Mb (to avoid conflicts), and so that they can
|
|
* be accessed via SPARSE space.
|
|
*
|
|
* We accept the risk that a broken Myrinet card will be put into a true XL
|
|
* and thus can more easily run into the problem described below.
|
|
*/
|
|
#define XL_DEFAULT_MEM_BASE ((16+2)*1024*1024) /* 16M to 64M-1 is avail */
|
|
|
|
/*
|
|
* APECS and LCA have only 34 bits for physical addresses, thus limiting PCI
|
|
* bus memory addresses for SPARSE access to be less than 128Mb.
|
|
*/
|
|
#define APECS_AND_LCA_DEFAULT_MEM_BASE ((16+2)*1024*1024)
|
|
|
|
/*
|
|
* Because MCPCIA and T2 core logic support more bits for
|
|
* physical addresses, they should allow an expanded range of SPARSE
|
|
* memory addresses. However, we do not use them all, in order to
|
|
* avoid the HAE manipulation that would be needed.
|
|
*/
|
|
#define MCPCIA_DEFAULT_MEM_BASE ((32+2)*1024*1024)
|
|
#define T2_DEFAULT_MEM_BASE ((16+1)*1024*1024)
|
|
|
|
/*
|
|
* Because CIA and PYXIS have more bits for physical addresses,
|
|
* they support an expanded range of SPARSE memory addresses.
|
|
*/
|
|
#define DEFAULT_MEM_BASE ((128+16)*1024*1024)
|
|
|
|
/* ??? Experimenting with no HAE for CIA. */
|
|
#define CIA_DEFAULT_MEM_BASE ((32+2)*1024*1024)
|
|
|
|
#define IRONGATE_DEFAULT_MEM_BASE ((256*8-16)*1024*1024)
|
|
|
|
#define DEFAULT_AGP_APER_SIZE (64*1024*1024)
|
|
|
|
/*
|
|
* A small note about bridges and interrupts. The DECchip 21050 (and
|
|
* later) adheres to the PCI-PCI bridge specification. This says that
|
|
* the interrupts on the other side of a bridge are swizzled in the
|
|
* following manner:
|
|
*
|
|
* Dev Interrupt Interrupt
|
|
* Pin on Pin on
|
|
* Device Connector
|
|
*
|
|
* 4 A A
|
|
* B B
|
|
* C C
|
|
* D D
|
|
*
|
|
* 5 A B
|
|
* B C
|
|
* C D
|
|
* D A
|
|
*
|
|
* 6 A C
|
|
* B D
|
|
* C A
|
|
* D B
|
|
*
|
|
* 7 A D
|
|
* B A
|
|
* C B
|
|
* D C
|
|
*
|
|
* Where A = pin 1, B = pin 2 and so on and pin=0 = default = A.
|
|
* Thus, each swizzle is ((pin-1) + (device#-4)) % 4
|
|
*
|
|
* pci_swizzle_interrupt_pin() swizzles for exactly one bridge. The routine
|
|
* pci_common_swizzle() handles multiple bridges. But there are a
|
|
* couple boards that do strange things.
|
|
*/
|
|
|
|
|
|
/* The following macro is used to implement the table-based irq mapping
|
|
function for all single-bus Alphas. */
|
|
|
|
#define COMMON_TABLE_LOOKUP \
|
|
({ long _ctl_ = -1; \
|
|
if (slot >= min_idsel && slot <= max_idsel && pin < irqs_per_slot) \
|
|
_ctl_ = irq_tab[slot - min_idsel][pin]; \
|
|
_ctl_; })
|
|
|
|
|
|
/* A PCI IOMMU allocation arena. There are typically two of these
|
|
regions per bus. */
|
|
/* ??? The 8400 has a 32-byte pte entry, and the entire table apparently
|
|
lives directly on the host bridge (no tlb?). We don't support this
|
|
machine, but if we ever did, we'd need to parameterize all this quite
|
|
a bit further. Probably with per-bus operation tables. */
|
|
|
|
struct pci_iommu_arena
|
|
{
|
|
spinlock_t lock;
|
|
struct pci_controller *hose;
|
|
#define IOMMU_INVALID_PTE 0x2 /* 32:63 bits MBZ */
|
|
#define IOMMU_RESERVED_PTE 0xface
|
|
unsigned long *ptes;
|
|
dma_addr_t dma_base;
|
|
unsigned int size;
|
|
unsigned int next_entry;
|
|
unsigned int align_entry;
|
|
};
|
|
|
|
#if defined(CONFIG_ALPHA_SRM) && \
|
|
(defined(CONFIG_ALPHA_CIA) || defined(CONFIG_ALPHA_LCA))
|
|
# define NEED_SRM_SAVE_RESTORE
|
|
#else
|
|
# undef NEED_SRM_SAVE_RESTORE
|
|
#endif
|
|
|
|
#if defined(CONFIG_ALPHA_GENERIC) || defined(NEED_SRM_SAVE_RESTORE)
|
|
# define ALPHA_RESTORE_SRM_SETUP
|
|
#else
|
|
# undef ALPHA_RESTORE_SRM_SETUP
|
|
#endif
|
|
|
|
#ifdef ALPHA_RESTORE_SRM_SETUP
|
|
/* Store PCI device configuration left by SRM here. */
|
|
struct pdev_srm_saved_conf
|
|
{
|
|
struct pdev_srm_saved_conf *next;
|
|
struct pci_dev *dev;
|
|
};
|
|
|
|
extern void pci_restore_srm_config(void);
|
|
#else
|
|
#define pdev_save_srm_config(dev) do {} while (0)
|
|
#define pci_restore_srm_config() do {} while (0)
|
|
#endif
|
|
|
|
/* The hose list. */
|
|
extern struct pci_controller *hose_head, **hose_tail;
|
|
extern struct pci_controller *pci_isa_hose;
|
|
|
|
/* Indicate that we trust the console to configure things properly. */
|
|
extern int pci_probe_only;
|
|
|
|
extern unsigned long alpha_agpgart_size;
|
|
|
|
extern void common_init_pci(void);
|
|
#define common_swizzle pci_common_swizzle
|
|
extern struct pci_controller *alloc_pci_controller(void);
|
|
extern struct resource *alloc_resource(void);
|
|
|
|
extern struct pci_iommu_arena *iommu_arena_new_node(int,
|
|
struct pci_controller *,
|
|
dma_addr_t, unsigned long,
|
|
unsigned long);
|
|
extern struct pci_iommu_arena *iommu_arena_new(struct pci_controller *,
|
|
dma_addr_t, unsigned long,
|
|
unsigned long);
|
|
extern const char *const pci_io_names[];
|
|
extern const char *const pci_mem_names[];
|
|
extern const char pci_hae0_name[];
|
|
|
|
extern unsigned long size_for_memory(unsigned long max);
|
|
|
|
extern int iommu_reserve(struct pci_iommu_arena *, long, long);
|
|
extern int iommu_release(struct pci_iommu_arena *, long, long);
|
|
extern int iommu_bind(struct pci_iommu_arena *, long, long, unsigned long *);
|
|
extern int iommu_unbind(struct pci_iommu_arena *, long, long);
|
|
|
|
|