a4ed06ad83
The pl010 primecell documentation specifies that an error indicated via RSR should be cleared by a write to ECR. We didn't do this, which was causing errors to be re-reported on every call to pl010_rx_chars(). Doing a write to ECR once we detect an error appears to prevent the ep93xx console UART driver from going into a mode where it reports "ttyAM0: X input overrun(s)" every couple of keystrokes. Signed-off-by: Lennert Buytenhek <buytenh@wantstofly.org> Signed-off-by: Andrew Morton <akpm@osdl.org> Signed-off-by: Linus Torvalds <torvalds@osdl.org> |
||
|---|---|---|
| .. | ||
| cpm_uart | ||
| jsm | ||
| 8250.c | ||
| 8250.h | ||
| 8250_accent.c | ||
| 8250_acorn.c | ||
| 8250_au1x00.c | ||
| 8250_boca.c | ||
| 8250_early.c | ||
| 8250_exar_st16c554.c | ||
| 8250_fourport.c | ||
| 8250_gsc.c | ||
| 8250_hp300.c | ||
| 8250_hub6.c | ||
| 8250_mca.c | ||
| 8250_pci.c | ||
| 8250_pnp.c | ||
| 21285.c | ||
| 68328serial.c | ||
| 68328serial.h | ||
| 68360serial.c | ||
| Kconfig | ||
| Makefile | ||
| amba-pl010.c | ||
| amba-pl011.c | ||
| atmel_serial.c | ||
| atmel_serial.h | ||
| clps711x.c | ||
| crisv10.c | ||
| crisv10.h | ||
| dz.c | ||
| dz.h | ||
| icom.c | ||
| icom.h | ||
| imx.c | ||
| ioc3_serial.c | ||
| ioc4_serial.c | ||
| ip22zilog.c | ||
| ip22zilog.h | ||
| m32r_sio.c | ||
| m32r_sio.h | ||
| m32r_sio_reg.h | ||
| mcfserial.c | ||
| mcfserial.h | ||
| mpc52xx_uart.c | ||
| mpsc.c | ||
| mux.c | ||
| netx-serial.c | ||
| pmac_zilog.c | ||
| pmac_zilog.h | ||
| pxa.c | ||
| s3c2410.c | ||
| sa1100.c | ||
| serial_core.c | ||
| serial_cs.c | ||
| serial_lh7a40x.c | ||
| serial_txx9.c | ||
| sh-sci.c | ||
| sh-sci.h | ||
| sn_console.c | ||
| suncore.c | ||
| suncore.h | ||
| sunhv.c | ||
| sunsab.c | ||
| sunsab.h | ||
| sunsu.c | ||
| sunzilog.c | ||
| sunzilog.h | ||
| uartlite.c | ||
| v850e_uart.c | ||
| vr41xx_siu.c | ||