261 lines
6.9 KiB
C
261 lines
6.9 KiB
C
/* orinoco_tmd.c
|
|
*
|
|
* Driver for Prism II devices which would usually be driven by orinoco_cs,
|
|
* but are connected to the PCI bus by a TMD7160.
|
|
*
|
|
* Copyright (C) 2003 Joerg Dorchain <joerg AT dorchain.net>
|
|
* based heavily upon orinoco_plx.c Copyright (C) 2001 Daniel Barlow
|
|
*
|
|
* The contents of this file are subject to the Mozilla Public License
|
|
* Version 1.1 (the "License"); you may not use this file except in
|
|
* compliance with the License. You may obtain a copy of the License
|
|
* at http://www.mozilla.org/MPL/
|
|
*
|
|
* Software distributed under the License is distributed on an "AS IS"
|
|
* basis, WITHOUT WARRANTY OF ANY KIND, either express or implied. See
|
|
* the License for the specific language governing rights and
|
|
* limitations under the License.
|
|
*
|
|
* Alternatively, the contents of this file may be used under the
|
|
* terms of the GNU General Public License version 2 (the "GPL"), in
|
|
* which case the provisions of the GPL are applicable instead of the
|
|
* above. If you wish to allow the use of your version of this file
|
|
* only under the terms of the GPL and not to allow others to use your
|
|
* version of this file under the MPL, indicate your decision by
|
|
* deleting the provisions above and replace them with the notice and
|
|
* other provisions required by the GPL. If you do not delete the
|
|
* provisions above, a recipient may use your version of this file
|
|
* under either the MPL or the GPL.
|
|
|
|
* Caution: this is experimental and probably buggy. For success and
|
|
* failure reports for different cards and adaptors, see
|
|
* orinoco_tmd_pci_id_table near the end of the file. If you have a
|
|
* card we don't have the PCI id for, and looks like it should work,
|
|
* drop me mail with the id and "it works"/"it doesn't work".
|
|
*
|
|
* Note: if everything gets detected fine but it doesn't actually send
|
|
* or receive packets, your first port of call should probably be to
|
|
* try newer firmware in the card. Especially if you're doing Ad-Hoc
|
|
* modes
|
|
*
|
|
* The actual driving is done by orinoco.c, this is just resource
|
|
* allocation stuff.
|
|
*
|
|
* This driver is modeled after the orinoco_plx driver. The main
|
|
* difference is that the TMD chip has only IO port ranges and no
|
|
* memory space, i.e. no access to the CIS. Compared to the PLX chip,
|
|
* the io range functionalities are exchanged.
|
|
*
|
|
* Pheecom sells cards with the TMD chip as "ASIC version"
|
|
*/
|
|
|
|
#define DRIVER_NAME "orinoco_tmd"
|
|
#define PFX DRIVER_NAME ": "
|
|
|
|
#include <linux/config.h>
|
|
#include <linux/module.h>
|
|
#include <linux/kernel.h>
|
|
#include <linux/init.h>
|
|
#include <linux/delay.h>
|
|
#include <linux/pci.h>
|
|
#include <pcmcia/cisreg.h>
|
|
|
|
#include "orinoco.h"
|
|
|
|
#define COR_VALUE (COR_LEVEL_REQ | COR_FUNC_ENA) /* Enable PC card with interrupt in level trigger */
|
|
#define COR_RESET (0x80) /* reset bit in the COR register */
|
|
#define TMD_RESET_TIME (500) /* milliseconds */
|
|
|
|
/* Orinoco TMD specific data */
|
|
struct orinoco_tmd_card {
|
|
u32 tmd_io;
|
|
};
|
|
|
|
|
|
/*
|
|
* Do a soft reset of the card using the Configuration Option Register
|
|
*/
|
|
static int orinoco_tmd_cor_reset(struct orinoco_private *priv)
|
|
{
|
|
hermes_t *hw = &priv->hw;
|
|
struct orinoco_tmd_card *card = priv->card;
|
|
u32 addr = card->tmd_io;
|
|
unsigned long timeout;
|
|
u16 reg;
|
|
|
|
outb(COR_VALUE | COR_RESET, addr);
|
|
mdelay(1);
|
|
|
|
outb(COR_VALUE, addr);
|
|
mdelay(1);
|
|
|
|
/* Just in case, wait more until the card is no longer busy */
|
|
timeout = jiffies + (TMD_RESET_TIME * HZ / 1000);
|
|
reg = hermes_read_regn(hw, CMD);
|
|
while (time_before(jiffies, timeout) && (reg & HERMES_CMD_BUSY)) {
|
|
mdelay(1);
|
|
reg = hermes_read_regn(hw, CMD);
|
|
}
|
|
|
|
/* Did we timeout ? */
|
|
if (reg & HERMES_CMD_BUSY) {
|
|
printk(KERN_ERR PFX "Busy timeout\n");
|
|
return -ETIMEDOUT;
|
|
}
|
|
|
|
return 0;
|
|
}
|
|
|
|
|
|
static int orinoco_tmd_init_one(struct pci_dev *pdev,
|
|
const struct pci_device_id *ent)
|
|
{
|
|
int err = 0;
|
|
struct orinoco_private *priv = NULL;
|
|
struct orinoco_tmd_card *card;
|
|
struct net_device *dev = NULL;
|
|
void __iomem *mem;
|
|
|
|
err = pci_enable_device(pdev);
|
|
if (err) {
|
|
printk(KERN_ERR PFX "Cannot enable PCI device\n");
|
|
return err;
|
|
}
|
|
|
|
err = pci_request_regions(pdev, DRIVER_NAME);
|
|
if (err != 0) {
|
|
printk(KERN_ERR PFX "Cannot obtain PCI resources\n");
|
|
goto fail_resources;
|
|
}
|
|
|
|
mem = pci_iomap(pdev, 2, 0);
|
|
if (! mem) {
|
|
err = -ENOMEM;
|
|
goto fail_iomap;
|
|
}
|
|
|
|
/* Allocate network device */
|
|
dev = alloc_orinocodev(sizeof(*card), orinoco_tmd_cor_reset);
|
|
if (! dev) {
|
|
printk(KERN_ERR PFX "Cannot allocate network device\n");
|
|
err = -ENOMEM;
|
|
goto fail_alloc;
|
|
}
|
|
|
|
priv = netdev_priv(dev);
|
|
card = priv->card;
|
|
card->tmd_io = pci_resource_start(pdev, 1);
|
|
dev->base_addr = pci_resource_start(pdev, 2);
|
|
SET_MODULE_OWNER(dev);
|
|
SET_NETDEV_DEV(dev, &pdev->dev);
|
|
|
|
hermes_struct_init(&priv->hw, mem, HERMES_16BIT_REGSPACING);
|
|
|
|
printk(KERN_DEBUG PFX "Detected Orinoco/Prism2 TMD device "
|
|
"at %s irq:%d, io addr:0x%lx\n", pci_name(pdev), pdev->irq,
|
|
dev->base_addr);
|
|
|
|
err = request_irq(pdev->irq, orinoco_interrupt, SA_SHIRQ,
|
|
dev->name, dev);
|
|
if (err) {
|
|
printk(KERN_ERR PFX "Cannot allocate IRQ %d\n", pdev->irq);
|
|
err = -EBUSY;
|
|
goto fail_irq;
|
|
}
|
|
dev->irq = pdev->irq;
|
|
|
|
err = orinoco_tmd_cor_reset(priv);
|
|
if (err) {
|
|
printk(KERN_ERR PFX "Initial reset failed\n");
|
|
goto fail;
|
|
}
|
|
|
|
err = register_netdev(dev);
|
|
if (err) {
|
|
printk(KERN_ERR PFX "Cannot register network device\n");
|
|
goto fail;
|
|
}
|
|
|
|
pci_set_drvdata(pdev, dev);
|
|
|
|
return 0;
|
|
|
|
fail:
|
|
free_irq(pdev->irq, dev);
|
|
|
|
fail_irq:
|
|
pci_set_drvdata(pdev, NULL);
|
|
free_orinocodev(dev);
|
|
|
|
fail_alloc:
|
|
pci_iounmap(pdev, mem);
|
|
|
|
fail_iomap:
|
|
pci_release_regions(pdev);
|
|
|
|
fail_resources:
|
|
pci_disable_device(pdev);
|
|
|
|
return err;
|
|
}
|
|
|
|
static void __devexit orinoco_tmd_remove_one(struct pci_dev *pdev)
|
|
{
|
|
struct net_device *dev = pci_get_drvdata(pdev);
|
|
struct orinoco_private *priv = dev->priv;
|
|
|
|
BUG_ON(! dev);
|
|
|
|
unregister_netdev(dev);
|
|
free_irq(dev->irq, dev);
|
|
pci_set_drvdata(pdev, NULL);
|
|
free_orinocodev(dev);
|
|
pci_iounmap(pdev, priv->hw.iobase);
|
|
pci_release_regions(pdev);
|
|
pci_disable_device(pdev);
|
|
}
|
|
|
|
|
|
static struct pci_device_id orinoco_tmd_pci_id_table[] = {
|
|
{0x15e8, 0x0131, PCI_ANY_ID, PCI_ANY_ID,}, /* NDC and OEMs, e.g. pheecom */
|
|
{0,},
|
|
};
|
|
|
|
MODULE_DEVICE_TABLE(pci, orinoco_tmd_pci_id_table);
|
|
|
|
static struct pci_driver orinoco_tmd_driver = {
|
|
.name = DRIVER_NAME,
|
|
.id_table = orinoco_tmd_pci_id_table,
|
|
.probe = orinoco_tmd_init_one,
|
|
.remove = __devexit_p(orinoco_tmd_remove_one),
|
|
};
|
|
|
|
static char version[] __initdata = DRIVER_NAME " " DRIVER_VERSION
|
|
" (Joerg Dorchain <joerg@dorchain.net>)";
|
|
MODULE_AUTHOR("Joerg Dorchain <joerg@dorchain.net>");
|
|
MODULE_DESCRIPTION("Driver for wireless LAN cards using the TMD7160 PCI bridge");
|
|
MODULE_LICENSE("Dual MPL/GPL");
|
|
|
|
static int __init orinoco_tmd_init(void)
|
|
{
|
|
printk(KERN_DEBUG "%s\n", version);
|
|
return pci_module_init(&orinoco_tmd_driver);
|
|
}
|
|
|
|
static void __exit orinoco_tmd_exit(void)
|
|
{
|
|
pci_unregister_driver(&orinoco_tmd_driver);
|
|
ssleep(1);
|
|
}
|
|
|
|
module_init(orinoco_tmd_init);
|
|
module_exit(orinoco_tmd_exit);
|
|
|
|
/*
|
|
* Local variables:
|
|
* c-indent-level: 8
|
|
* c-basic-offset: 8
|
|
* tab-width: 8
|
|
* End:
|
|
*/
|