152 lines
3.8 KiB
C
152 lines
3.8 KiB
C
/*
|
|
* Copyright (C) 2004-2007 Atmel Corporation
|
|
*
|
|
* This program is free software; you can redistribute it and/or modify
|
|
* it under the terms of the GNU General Public License version 2 as
|
|
* published by the Free Software Foundation.
|
|
*/
|
|
#include <linux/clk.h>
|
|
#include <linux/clockchips.h>
|
|
#include <linux/init.h>
|
|
#include <linux/interrupt.h>
|
|
#include <linux/irq.h>
|
|
#include <linux/kernel.h>
|
|
#include <linux/time.h>
|
|
|
|
#include <asm/sysreg.h>
|
|
|
|
#include <mach/pm.h>
|
|
|
|
|
|
static cycle_t read_cycle_count(struct clocksource *cs)
|
|
{
|
|
return (cycle_t)sysreg_read(COUNT);
|
|
}
|
|
|
|
/*
|
|
* The architectural cycle count registers are a fine clocksource unless
|
|
* the system idle loop use sleep states like "idle": the CPU cycles
|
|
* measured by COUNT (and COMPARE) don't happen during sleep states.
|
|
* Their duration also changes if cpufreq changes the CPU clock rate.
|
|
* So we rate the clocksource using COUNT as very low quality.
|
|
*/
|
|
static struct clocksource counter = {
|
|
.name = "avr32_counter",
|
|
.rating = 50,
|
|
.read = read_cycle_count,
|
|
.mask = CLOCKSOURCE_MASK(32),
|
|
.shift = 16,
|
|
.flags = CLOCK_SOURCE_IS_CONTINUOUS,
|
|
};
|
|
|
|
static irqreturn_t timer_interrupt(int irq, void *dev_id)
|
|
{
|
|
struct clock_event_device *evdev = dev_id;
|
|
|
|
if (unlikely(!(intc_get_pending(0) & 1)))
|
|
return IRQ_NONE;
|
|
|
|
/*
|
|
* Disable the interrupt until the clockevent subsystem
|
|
* reprograms it.
|
|
*/
|
|
sysreg_write(COMPARE, 0);
|
|
|
|
evdev->event_handler(evdev);
|
|
return IRQ_HANDLED;
|
|
}
|
|
|
|
static struct irqaction timer_irqaction = {
|
|
.handler = timer_interrupt,
|
|
/* Oprofile uses the same irq as the timer, so allow it to be shared */
|
|
.flags = IRQF_TIMER | IRQF_DISABLED | IRQF_SHARED,
|
|
.name = "avr32_comparator",
|
|
};
|
|
|
|
static int comparator_next_event(unsigned long delta,
|
|
struct clock_event_device *evdev)
|
|
{
|
|
unsigned long flags;
|
|
|
|
raw_local_irq_save(flags);
|
|
|
|
/* The time to read COUNT then update COMPARE must be less
|
|
* than the min_delta_ns value for this clockevent source.
|
|
*/
|
|
sysreg_write(COMPARE, (sysreg_read(COUNT) + delta) ? : 1);
|
|
|
|
raw_local_irq_restore(flags);
|
|
|
|
return 0;
|
|
}
|
|
|
|
static void comparator_mode(enum clock_event_mode mode,
|
|
struct clock_event_device *evdev)
|
|
{
|
|
switch (mode) {
|
|
case CLOCK_EVT_MODE_ONESHOT:
|
|
pr_debug("%s: start\n", evdev->name);
|
|
/* FALLTHROUGH */
|
|
case CLOCK_EVT_MODE_RESUME:
|
|
cpu_disable_idle_sleep();
|
|
break;
|
|
case CLOCK_EVT_MODE_UNUSED:
|
|
case CLOCK_EVT_MODE_SHUTDOWN:
|
|
sysreg_write(COMPARE, 0);
|
|
pr_debug("%s: stop\n", evdev->name);
|
|
cpu_enable_idle_sleep();
|
|
break;
|
|
default:
|
|
BUG();
|
|
}
|
|
}
|
|
|
|
static struct clock_event_device comparator = {
|
|
.name = "avr32_comparator",
|
|
.features = CLOCK_EVT_FEAT_ONESHOT,
|
|
.shift = 16,
|
|
.rating = 50,
|
|
.set_next_event = comparator_next_event,
|
|
.set_mode = comparator_mode,
|
|
};
|
|
|
|
void __init time_init(void)
|
|
{
|
|
unsigned long counter_hz;
|
|
int ret;
|
|
|
|
xtime.tv_sec = mktime(2007, 1, 1, 0, 0, 0);
|
|
xtime.tv_nsec = 0;
|
|
|
|
set_normalized_timespec(&wall_to_monotonic,
|
|
-xtime.tv_sec, -xtime.tv_nsec);
|
|
|
|
/* figure rate for counter */
|
|
counter_hz = clk_get_rate(boot_cpu_data.clk);
|
|
counter.mult = clocksource_hz2mult(counter_hz, counter.shift);
|
|
|
|
ret = clocksource_register(&counter);
|
|
if (ret)
|
|
pr_debug("timer: could not register clocksource: %d\n", ret);
|
|
|
|
/* setup COMPARE clockevent */
|
|
comparator.mult = div_sc(counter_hz, NSEC_PER_SEC, comparator.shift);
|
|
comparator.max_delta_ns = clockevent_delta2ns((u32)~0, &comparator);
|
|
comparator.min_delta_ns = clockevent_delta2ns(50, &comparator) + 1;
|
|
comparator.cpumask = cpumask_of(0);
|
|
|
|
sysreg_write(COMPARE, 0);
|
|
timer_irqaction.dev_id = &comparator;
|
|
|
|
ret = setup_irq(0, &timer_irqaction);
|
|
if (ret)
|
|
pr_debug("timer: could not request IRQ 0: %d\n", ret);
|
|
else {
|
|
clockevents_register_device(&comparator);
|
|
|
|
pr_info("%s: irq 0, %lu.%03lu MHz\n", comparator.name,
|
|
((counter_hz + 500) / 1000) / 1000,
|
|
((counter_hz + 500) / 1000) % 1000);
|
|
}
|
|
}
|