linux-stable-rt/drivers/scsi/pm8001/pm8001_defs.h

113 lines
3.5 KiB
C

/*
* PMC-Sierra SPC 8001 SAS/SATA based host adapters driver
*
* Copyright (c) 2008-2009 USI Co., Ltd.
* All rights reserved.
*
* Redistribution and use in source and binary forms, with or without
* modification, are permitted provided that the following conditions
* are met:
* 1. Redistributions of source code must retain the above copyright
* notice, this list of conditions, and the following disclaimer,
* without modification.
* 2. Redistributions in binary form must reproduce at minimum a disclaimer
* substantially similar to the "NO WARRANTY" disclaimer below
* ("Disclaimer") and any redistribution must be conditioned upon
* including a substantially similar Disclaimer requirement for further
* binary redistribution.
* 3. Neither the names of the above-listed copyright holders nor the names
* of any contributors may be used to endorse or promote products derived
* from this software without specific prior written permission.
*
* Alternatively, this software may be distributed under the terms of the
* GNU General Public License ("GPL") version 2 as published by the Free
* Software Foundation.
*
* NO WARRANTY
* THIS SOFTWARE IS PROVIDED BY THE COPYRIGHT HOLDERS AND CONTRIBUTORS
* "AS IS" AND ANY EXPRESS OR IMPLIED WARRANTIES, INCLUDING, BUT NOT
* LIMITED TO, THE IMPLIED WARRANTIES OF MERCHANTIBILITY AND FITNESS FOR
* A PARTICULAR PURPOSE ARE DISCLAIMED. IN NO EVENT SHALL THE COPYRIGHT
* HOLDERS OR CONTRIBUTORS BE LIABLE FOR SPECIAL, EXEMPLARY, OR CONSEQUENTIAL
* DAMAGES (INCLUDING, BUT NOT LIMITED TO, PROCUREMENT OF SUBSTITUTE GOODS
* OR SERVICES; LOSS OF USE, DATA, OR PROFITS; OR BUSINESS INTERRUPTION)
* HOWEVER CAUSED AND ON ANY THEORY OF LIABILITY, WHETHER IN CONTRACT,
* STRICT LIABILITY, OR TORT (INCLUDING NEGLIGENCE OR OTHERWISE) ARISING
* IN ANY WAY OUT OF THE USE OF THIS SOFTWARE, EVEN IF ADVISED OF THE
* POSSIBILITY OF SUCH DAMAGES.
*
*/
#ifndef _PM8001_DEFS_H_
#define _PM8001_DEFS_H_
enum chip_flavors {
chip_8001,
};
#define USI_MAX_MEMCNT 9
#define PM8001_MAX_DMA_SG SG_ALL
enum phy_speed {
PHY_SPEED_15 = 0x01,
PHY_SPEED_30 = 0x02,
PHY_SPEED_60 = 0x04,
};
enum data_direction {
DATA_DIR_NONE = 0x0, /* NO TRANSFER */
DATA_DIR_IN = 0x01, /* INBOUND */
DATA_DIR_OUT = 0x02, /* OUTBOUND */
DATA_DIR_BYRECIPIENT = 0x04, /* UNSPECIFIED */
};
enum port_type {
PORT_TYPE_SAS = (1L << 1),
PORT_TYPE_SATA = (1L << 0),
};
/* driver compile-time configuration */
#define PM8001_MAX_CCB 512 /* max ccbs supported */
#define PM8001_MAX_INB_NUM 1
#define PM8001_MAX_OUTB_NUM 1
#define PM8001_CAN_QUEUE 128 /* SCSI Queue depth */
/* unchangeable hardware details */
#define PM8001_MAX_PHYS 8 /* max. possible phys */
#define PM8001_MAX_PORTS 8 /* max. possible ports */
#define PM8001_MAX_DEVICES 1024 /* max supported device */
enum memory_region_num {
AAP1 = 0x0, /* application acceleration processor */
IOP, /* IO processor */
CI, /* consumer index */
PI, /* producer index */
IB, /* inbound queue */
OB, /* outbound queue */
NVMD, /* NVM device */
DEV_MEM, /* memory for devices */
CCB_MEM, /* memory for command control block */
};
#define PM8001_EVENT_LOG_SIZE (128 * 1024)
/*error code*/
enum mpi_err {
MPI_IO_STATUS_SUCCESS = 0x0,
MPI_IO_STATUS_BUSY = 0x01,
MPI_IO_STATUS_FAIL = 0x02,
};
/**
* Phy Control constants
*/
enum phy_control_type {
PHY_LINK_RESET = 0x01,
PHY_HARD_RESET = 0x02,
PHY_NOTIFY_ENABLE_SPINUP = 0x10,
};
enum pm8001_hba_info_flags {
PM8001F_INIT_TIME = (1U << 0),
PM8001F_RUN_TIME = (1U << 1),
};
#endif