David Brownell f6e10b865c mmc: warn about voltage mismatches ... Get rid of a silent failure mode when the MMC/SD host doesn't support the voltages needed to operate a given card, by adding a warning. A 3.3V host and a 3.0V card, for example, no longer need to mysteriously just not work at all. This isn't the best diagnostic; ideally it would also tell what voltage the card and host support (and not just by dumping the bitmasks). Signed-off-by: David Brownell <dbrownell@users.sourceforge.net> Signed-off-by: Pierre Ossman <drzeus@drzeus.cx>		2008-12-31 19:27:18 +01:00
..
Kconfig	…
Makefile	…
bus.c	mmc: struct device - replace bus_id with dev_name(), dev_set_name()	2008-11-08 21:37:46 +01:00
bus.h	…
core.c	mmc: warn about voltage mismatches	2008-12-31 19:27:18 +01:00
core.h	mmc: Add per-card debugfs support	2008-07-27 01:26:17 +02:00
debugfs.c	mmc: Add per-card debugfs support	2008-07-27 01:26:17 +02:00
host.c	mmc: struct device - replace bus_id with dev_name(), dev_set_name()	2008-11-08 21:37:46 +01:00
host.h	…
mmc.c	mmc: Add 8-bit bus width support	2008-12-31 18:18:12 +01:00
mmc_ops.c	MMC: CSD and CID timeout values	2008-10-12 11:04:37 +02:00
mmc_ops.h	…
sd.c	…
sd_ops.c	…
sd_ops.h	…
sdio.c	sdio: high-speed support	2008-10-12 11:04:34 +02:00
sdio_bus.c	mmc: struct device - replace bus_id with dev_name(), dev_set_name()	2008-11-08 21:37:46 +01:00
sdio_bus.h	…
sdio_cis.c	…
sdio_cis.h	…
sdio_io.c	…
sdio_irq.c	sdio: give sdio irq thread a host specific name	2008-10-12 11:04:30 +02:00
sdio_ops.c	…
sdio_ops.h	…